Cooking appliances · Boston, MA
Wolf Range Hood Repair
Wall, island and pro-style Wolf hoods, where a city duct run often makes the difference between quiet extraction and none. We service blowers and motors, speed controls, lighting, baffles and the ducting connections that loosen over time.
Word for word
What gets described on the phone
- Blower loud but moving very little air
- Hood lights working while the fan does nothing
- Rattle from the duct run when the fan steps up
- Grease dripping back down from the baffles
Blowers, dampers, baffles and the duct run behind them.
On the visit
What actually gets measured
- Blower current draw against the rating plate at every speed
- Baffle and mesh loading, plus the state of the grease trough
- Damper flap travel at the hood and again at the wall or roof cap
- The duct run itself: crushes, long flexible sections and reductions
Cost
The ranges this work falls into
Three things set the figure: which part failed, whether it is on the van or has to be ordered for the platform, and how much has to come apart to reach it. A spark module behind a control pod and an infrared broiler assembly are not the same afternoon — so these are bands, and your number is quoted after the diagnosis and before anything is opened.
- Igniter or spark module replacement $290–$680
- Burner valve or orifice service $260–$1,050
- Oven thermostat or sensor calibration $140–$730
- Convection fan or motor $330–$910
- Control board or touch panel $510–$1,590
- Door hinge, glass or seal $200–$920
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.
The other half of the decision is what a replacement costs. A comparable new pro range runs $6,350–$19,170 for the unit alone, before delivery, hookup, gas or electrical work and the cabinetry that almost always comes with it. That is why a control board is usually still the cheaper answer.
Reviews
On wolf range hood repair in particular
5
5 out of 5
The baffles were rattling loose in the frame and the whole hood hummed at any speed above the first. Whoever cleaned it last had bent the mounting clips out of shape. He straightened the frame back out, fitted new clips, and it runs silently again.
Callum D.Brookline
5 out of 5
Hood lights worked but the fan did nothing at all. The speed control board had failed, not the motor, which two other people had insisted it would be. Board replaced and it runs through all four speeds.
Astrid P.Charlestown
5 out of 5
Grease was dripping back off the baffles onto the range. The blower was undersized for a long run up through a hill house, and the damper had stuck. He replaced the damper and set the speeds properly.
Brendan M.Charlestown
Book a visit
Tell us the model and the fault. The figure follows.
A flat $95 service call covers the visit and the diagnosis, and comes off the bill when you approve the repair. Visits run 8:00 am – 8:00 pm, seven days; the line is answered 24/7.
